|
I have created a monitor for the VM Processor - % Processor time. The servers I'm running it on have 4 CPUS. The value can exceed 100 it can go to above 400 due to host overhead. The graph displayed on in the console only goes to 100 and when I attempt to run a report 100 is the highest value returned. Are values over 100 being dropped? |
|
Parker, Thank you for all of your help finding the issue with this counter! We now have a fix for you to install which will give you the values of the 100%. PA Server Monitor Release Candidate Thanks Please make sure to mark your questions accepted when you have your answer by clicking the gray check mark to the left of the answer. |
|
Hi Parker, Trying running an HTML table report to get the actual values. Are you getting values over 100? Thanks Please make sure to mark your questions accepted when you have your answer by clicking the gray check mark to the left of the answer. |
|
Now I can't a report generated: An error occurred while generating the page Details: Required parameters were not filled in. Try again and visit the "Filters and Parameters" tab. Please check the request and try again, or contact support@poweradmin.com Ver: 5.4.0 (Build 156) 05/15/14 14:44:11 |
|
Parker, When the CPU usage is over 100%, does perfmon.msc show the value over the 100% or does it stop at 100%? Thanks Please make sure to mark your questions accepted when you have your answer by clicking the gray check mark to the left of the answer. Perfmon shows values well over 100. It can go over 400 for a 4 CPU server as they also include host overhead. The graph chart only goes to 100 but you can see that the higher values in the "Last" display or if you highlight a point on the graph that stops at 100 but is over 100.
(16 May '14, 09:41)
pdr
I just got an alert from one of the servers, one of the amounts for the processer % for one of the processes doesn't make any sense though. [dm_agent_exec#3 = 268435198 %] 16 May 2014 09:53:57 AM
(16 May '14, 10:01)
pdr
|
|
Parker, Would you send us a screenshot of perfmon.msc showing the values at the high level. Please send the screenshot to support@poweradmin.com Thanks Please make sure to mark your questions accepted when you have your answer by clicking the gray check mark to the left of the answer. Sorry didn't see your response. Just sent the screen shot.
(29 May '14, 14:35)
pdr
I'm playing with the alert and it seems if I set the value I'm checking for over 99 we get no alerts even though I've told it to alert on changes and I know it goes over 100. Still can't generate an Adhoc report, all filters and parameters are filled in.
(04 Jun '14, 07:55)
pdr
|